Your motorcycle is more than just a machine. Treat her well and she will thank you with better performance and greater safety when you drive her. Washing the bike is a process in which you have to follow certain rules with which you will achieve an optimal result. Here, we’ll discuss how to wash your motorcycle correctly? 

How to wash your motorcycle correctly?

Cleaning your motorcycle can be a nuisance, and an investment of time: try to take it on the positive side and enjoy that little while! And if you cannot see the positive side of doing it, save to take it to a specialized place to take care of it. Do not know where to start? How about motorcycle insurance? In just 60 seconds you can see how much you would save with a new motorbike insurance. Keep reading: Test Lifan E3: a truly economic electric moped

Before taking care of the exterior, dedicate yourself to the cleaning of the engine with a spray of lava motor liquid and a brush. Let this liquid sit a little first and then wash it with a water hose.

Use water

You can use water under pressure to make your motorcycle clean, but do not get excited too and take care where you aim, because with the force of water you can damage parts such as protectors, accessories or even paint. It is better that you use a normal pressure hose, anyway, and a soft sponge: the result will be the same and you will avoid problems: water under pressure can degrade rubber, bearings, get into electrical parts, and generate condensation.

If you decide to give a hose under pressure at the gas station or use a similar, try to keep the water at a good distance, half a meter at least. Do not give up, and do not be lazy: remove the most encrusted parts with the sponge and simply rinse the excess soap with the hose.

Wash cylinders

Although the water is good for the outside of your motorcycle, there are internal elements that do not accept it as much. Before washing the motorcycle, cover the hole in the exhaust pipe and the air intakes in a tight manner, with a plastic either fixed enough will suffice: you can find special rubber stoppers for exhaust, or a simple plastic bag will prevent leaks fill with water: On the one hand, the fiber absorbs moisture and loses qualities, and on the other, a puddle in the elbow of the exhaust does not do any good to your bike. If the hose generates a lot of pressure, the water could even reach the cylinders!

Check controls

You can also place the mirrors facing the floor so water does not enter, or put them in plastic bags. You must also protect the control panel, headlights, turn signals and other electrical appliances that your motorcycle may have so that the cleaning work is safe. Be careful to clean the chain with a pressure hose: you could damage the oil seals and O-rings.

Once the motorcycle is wet, you can soap it with a neutral dishwasher and a sponge. When rinsing it, remember again that the ideal thing is warm water or weather. Dry the motorcycle with a cloth, and give it one last check when the bike is practically dry with a damp.

Finally,

Devícate to grease the chain, and polish the chrome, you have many products at your disposal for these tasks. And since you are dedicating time to your bike, you can check the battery status, tire pressure or oil and coolant levels.

One last tip: Be careful to leave the gas station with the wet wheels: give them time to dry, and make a small taxi to make sure there is no water left in the brakes. Before storing the motorcycle in the garage, grease the chain again and let it rest.

And you’re ready to move with your brilliant machine! You might also like: http://www.autonags.com/5-safe-driving-tips-summer/